Whelen IW37UF6P Manuel d'utilisateur télécharger pdf

Page 1

ENGINEERING COMPANY INC.

USB

Port

Refer to the appropriate table

on page 2 for information on

the default configuration for

your application.

Connect to an ignition controlled

circuit that can accommodate an

additional 250mA load.

from lightbar

LIGHTBAR CABLE CONNECTOR

COLOR

RED

None

BLACK

GREEN

BLK/WHT

GREY

FUNCTION

+12VDC

GROUND

COMM. A

SHIELD

COMM. B

POS

Installation Guide:

Control Point Module

for WeCan® Lightbars

Form No.14695B (060514)

Automotive: Serial Communication

For warranty information regarding this product, visit www.whelen.com/warranty

Overview -

Note: If installing a WeCan lightbar into a system that includes

either a Whelen CenCom Sapphire or Whelen Cantrol, the

Control Point Module is no longer required. The lightbar can be

plugged directly into either of the previously mentioned units. In

that event, please refer to the applicable instructional material

for connection information.

The Control Point Module serves as the ‘brains’ of the Whelen

WC Series lightbar. The module is programmed with the

WeCan™ Programming Software via the USB port and in turn,

provides the necessary signals that allow the lightbar to function

in the desired manner.

As represented in the WeCan™ Programming software, each of

the 18 inputs may be programmed to activate any number or

combination of the installed lightbar components. This is

accomplished by applying +12VDC to an input. The default

configurations for specific lightbars are shown on page 2.

Important - The pattern override feature will override all active

LED lightheads with the pattern override flash pattern.

Programming Procedure -

IMPORTANT - It is not necessary to program this device

unless

changes to the default configuration (for example

pattern or switch control changes) are desired.

1. Connect a USB cable from the host PC to the module’s

USB port.

2. Start the WeCan software on the host PC and open the

configuration to be programmed.

3. Click on the “WeCan” button on the menu bar. Select

“Control Point” then “Program” from the fly-out.

4. A window will open to confirm that you are about to

program a Control Point Module. Confirm that the USB

cable is connected to both the module and the PC and

then press “OK” to continue. The software will display a

window when the programming procedure has been

successfully completed.

5. Confirm proper operation of the module.

51 Winthrop Road

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 525-4078

Internet: www.whelen.com

Sales e-mail: [email protected]

Canadian Sales e-mail: autocan@whelen.com

Customer Service e-mail: cust[email protected]

1 2

Résumé du contenu

Page 1 - Control Point Module

Page 1®ENGINEERING COMPANY INC.USBPort189178167156145134123112101142536Refer to the appropriate tableon page 2 for information onthe default configura

Page 2

Page 2LIBERTY, JUSTICE, FREEDOM, FREEDOM 2 (SEQUENCE)Pos Color Function1 GRN Front Pattern 1 - Ultra Scan2 GRN/WHT 2 - CA Ultra3 GRN/BLK 3 - CA Single