Whelen SLN2VLED Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Whelen SLN2VLED. Whelen SLN2VLED User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 9
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Page 1
Installation Guide:
Liberty and Freedom LC Lightbars
®
ENGINEERING COMPANY INC.
Automotive: Lightbars
Safety First
This document provides all the necessary information to allow your Whelen product to be properly and safely installed.
Before beginning the installation and/or operation of your new product, the installation technician and operator must
read this manual completely. Important information is contained herein that could prevent serious injury or damage.
Proper installation of this product requires the installer to have a good understanding of automotive electronics,
systems and procedures.
Failure to use specified installation parts and/or hardware will void the product warranty!
If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components or other
vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling
begins. Also de-burr any holes and remove any metal shards or remnants. Install grommets into all wire
passage holes.
If this manual states that this product may be mounted with suction cups, magnets, tape or Velcro®, clean the
mounting surface with a 50/50 mix of isopropyl alcohol and water and dry thoroughly.
Do not install this product or route any wires in the deployment area of your air bag. Equipment mounted or
located in the air bag deployment area will damage or reduce the effectiveness of the air bag, or become a
projectile that could cause serious personal injury or death. Refer to your vehicle owners manual for the air bag
deployment area. The User/Installer assumes full responsibility to determine proper mounting location, based
on providing ultimate safety to all passengers inside the vehicle.
For this product to operate at optimum efficiency, a good electrical connection to chassis ground must be
made. The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE
(-) battery post.
If this product uses a remote device to activate or control this product, make sure that this control is located in
an area that allows both the vehicle and the control to be operated safely in any driving condition.
Do not attempt to activate or control this device in a hazardous driving situation.
This product contains either strobe light(s), halogen light(s), high-intensity LEDs or a combination of these
lights. Do not stare directly into these lights. Momentary blindness and/or eye damage could result.
Use only soap and water to clean the outer lens. Use of other chemicals could result in premature lens cracking
(crazing) and discoloration. Lenses in this condition have significantly reduced effectiveness and should be
replaced immediately. Inspect and operate this product regularly to confirm its proper operation and mounting
condition. Do not use a pressure washer to clean this product.
It is recommended that these instructions be stored in a safe place and referred to when performing
maintenance and/or reinstallation of this product.
FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS COULD RESULT IN DAMAGE TO
THE PRODUCT OR VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR PASSENGERS!
51 Winthrop Road
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: canad[email protected]
Customer Service e-mail: cust[email protected]
For warranty information regarding this product, visit www.whelen.com/warranty
©2003 Whelen Engineering Company Inc.
Form No.13745U (081010)
Vue de la page 0
1 2 3 4 5 6 7 8 9

Résumé du contenu

Page 1 - Automotive: Lightbars

Page 1Installation Guide:Liberty™ and Freedom™ LC Lightbars®ENGINEERING COMPANY INC.Automotive: LightbarsSafety FirstThis document provides all the ne

Page 2 - Permanent Mounting:

Page 2Insert foot into extrusion with locking plateattached.Twist mounting foot intopositionANCHORPLATELoosely secure foot and locking plate.Strap Mou

Page 3 - 5" Mounting Foot

Page 3NOTE: Unless otherwise specified, thelightbar mounting feet must be sitting asclose to the edge of the roof as possible.Mounting feet must also

Page 4 - Hi/Low Power (VIOLET):

Page 4Wire Color Function FuseGREEN . . . . . .Front Corner LEDs . . . . . . 1 AMPBLUE . . . . . . .Rear Corner LEDs . . . . . . 1 AMPGRN/WHT . . .

Page 5 - Halogen Lighthead

Page 5Lighthead mounting holessnap into the raised bosseson the lighthead bracket.Ears on lighthead bracketslide into channels inextrusion (base).Snap

Page 6 - LR11 ALLEY

Page 6BROWNREAR LED 1BROWNFRONT LED 1BROWNWHT/BRNGRAYORANGEWHT/ORGGREENFRONT LED 5YELLOWFRONT LED 4ORANGEFRONT LED 3REDFRONT LED 2REAR OF LIGHTBARBLUE

Page 7 - Rear of Lightbar

Page 7I.O. CARD ASSEMBLY("LC" SERIES)TDALLEY AUXREAR FRONT3 POS. CONN.P1-P2-P3-WHT-YELWHT-GRNN/CCable EXIT16 POS. CONN.VIOGRN-BLKGRN-WHTBLU-

Page 8 - PART NUMBER

Page 8DRIVERPASSNGR81 83316242384133613540595836FRONT OF LIGHTBARFRONT OF LIGHTBARBRNORGBROWNLED 1REDLED 2ORANGELED 3FRONT LED 1BROWNFRONT LED 2REDFR

Page 9 - QTY QTY QTY QTY

Page 913PASSENGER'SSIDEDRIVER'S SIDEFRONTLED 6 / BLU14REDLED 2BROWNLED 11816ORANGELED 3YELLOWLED 4GREENLED 517FRONTLED 3 / ORGFRONTLED 2 / R

Commentaires sur ces manuels

Pas de commentaire