Whelen 7097001 Manuel d'utilisateur télécharger pdf

Page 1

The conditions and tests required for TSO approval of this

article are minimum performance standards. It is the

responsibility of those installing this article either on or

within a specific type or class of aircraft to determine that

the aircraft installation conditions are within the TSO

standards. TSO articles must have separate approval for

installation in aircraft. The article may be installed only if

performed under 14 CFR part 43 or the applicable

airworthiness requirements.

ENGINEERING COMPANY INC.

Route 145, Winthrop Road,

Chester, Connecticut 06412

Phone: (860) 526-9504

Fax: (860) 526-2009

Internet: www.whelen.com

Sales/Service e-mail: aviation@whelen.com

Aviation

Installation Guide:

Models 7097001 (Green) and 7097002 (Red)

P/N:01-0770970-01 and 01-0770970-02,

LED Forward Position Light for

90159( ) or 90206( )

Form No.13957A (062005)

TSO-C30c

TYPE I & II

APPROVED

MADE IN THE U.S.A.

OPERATING INSTRUCTIONS:

Nominal Voltage: . . . . . . . . . . . . 28 VDC

Input Current:. . . . . . . . . . . . . . . 0.3 Amps

Weight: . . . . . . . . . . . . . . . . . . . . 0.17 lbs.

EQUIPMENT LIMITATIONS: The LED position light is approved as an

incandescent lamp replacement module, for installation in Whelen Model

90159( ) or Whelen Model 90206( ).

CONTINUED AIRWORTHINESS: The LED position light is designed with 6

LED’s. If any one LED fails, the unit must be repaired or replaced. Inspect

the lens for excessive scratches or pitting. Replace if necessary.

Model Shown:

7101102

Remove

these

items

Gasket

Lens

Retainer

Screw

Save

Removal Procedure...

1. Remove retainer screws, retainer, lens and

gasket from the wingtip assembly. Save these

components.

2. Remove and save the two position light

retainer screws.

3. Remove the position light retainer, lens, lamp

and lens gasket. These items may be saved

for use as spares.

70970

LED

Assembly

Note: Screws should be

alternately tightened

until the final torque

value has been

achieved!

Replacement Procedure...

1. Insert the LED assembly into the now vacant

lamp socket. The contact is 28VDC. The

chassis is ground.

2. Secure the 70970 LED assembly using the

position light retainer screws from Step 2.

Tighten these screws equally to maximum

torque value of 13 in./lbs.

3. Reinstall the gasket, lens, retainer and

retainer screws in their original location.

Tighten these screws equally to maximum

torque value of 13 in./lbs.

4. Update aircraft records, complete form 337

and obtain FAA field approval for installation.

Aviation 1

Résumé du contenu

Page 1 - Aviation

Page 1The conditions and tests required for TSO approval of thisarticle are minimum performance standards. It is theresponsibility of those installing

Modèles reliés 7097002

Commentaires sur ces manuels

Pas de commentaire

Whelen 7097001 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement aérien Whelen 7097001. Whelen 7097001 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés 7097002

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement aérien Whelen 7097001